Привет уважаемые знатоки. Прошу помощи, так как я в электронике полный ноль.
Имеем переключатель (включатель или подключатель) как хотите, в общем аппарат замыкающий контакты после команды с пульта дистанционного управления. Взято у китайцев как можете видеть. Кто нить знает как откалибровать уверенный прием сигнала с ПДУ. Там есть инструкция но какая то мутная, может кто сталкивался с таким и может по нормальному рассказать последовательность действий. Методом научного тыка вроде работало, но как то не стабильно. Питание подаю с блока питания и все горит готовое к работе. Ниже инструкция на ингглише.. ток хз поможет она или нет.
ОффтопикFirst,
Load power: 10A
Work: self-locking, interlocking and jog (by learning ways to select)
Encoding: Learning
Output: (1) output passive (ie the output relay signal)
(2) Output active (ie the output relay energized)
Receiving frequency: 315MHZ other frequencies to be made
Second, use:
Press any button remote control, if learning indicator is blinking, this remote can learn supporting the product.
1 clear: often hold the button to learn, learn indicator light, light off after 5 seconds, which means that clear success. Cleared, before
By supporting the remote control no longer works. Note: If the factory before supporting good, do not be cleared to operate!
2 Select work: clearing let go after the operation, two seconds after the light flashed, then the choice to let go of work for jog
Style; if it blinks twice and then let go, then select the self-locking works; if flash three, the next and then let go, then select Internet
Locks work,
3 matching remote control: choose a good way of working, hold down the learn button and hold, indicator light, release the hand, according to the desired matching
Remote control transmitter signal, the indicator flashes three after off, it indicates that the remote control has been studying this button. For more with remote control,
This step can be re-operation!
Note: This product can support remote fixed code and learning code remote control, if it is the same kind of fixed code remote control, simply press the remote has a good supporting
Controller can be programmed the same address code, can be equipped with any number of remote control; if learning code remote control, press the third step operation can be up to such a remote control
Only supporting 16, such as adding, the first remote control no longer works, and so on. If you find someone else's remote control can also control your open
Off (repeated code), then the first switch cleared, then the remote control into another address code, re-matching can be.
Ниже сам апарат и схемка.
лан вроде разобрался.